Alienfx Windows 103/26/2021
If Use color settings as default is active, first color from Color tab will be used for calm situation, and the second color from Monitoring tab will be uset for active situation, if its not active - both colors will taken from Monitoring tab (and colors from Color tab if monitoring is disabled).It only control lights, but can do a way more tricks then AWCC.
![]() After unpack, run alienfx-probe or alienfx-gui to check and set light names ( alienfx-ambient and alienfx-haptics will not work correctly wihout this operation). Then run, it shows some info, then switch lights to green one-by-one and prompt to enter devices and lights name (you can enter name or ID from high-level SDK - its also shown as a part of info). If you didnt see which light is changed, just press ENTER to skip it. Alienfx .Exe Number OfIts check 16 first lights into the system by default, but you can change this value runnning alienfx-probe.exe number of lights. The purpose of this app is to check low-level API and to prepare light names for other apps, this names are stored and will be used in alienfx-haptics and alienfx-ambient as a light names for UI. Ex: set-all255,0,0 for red lights, set-all255,0,0,128 for dimmed red. NB: For low-level, it requires lights setup using alienfx-probe -gui to work correctly. Ex: set-one0,1,0,0,255 - set light 2 at the device 1 to blue color. For low-level SDK, current active device will be used if devID0, otherwise it switch to device with ID provided. You can define up to 9 actions in this command, but only first 1 or 2 will be used for high-level API and for older devices. ![]() For low-level api V3, it also support breath, spectrum, rainbow. If more, then one zone selected for light, it will try to blend zone colors into one. You can also press Reset button to re-initialize screen capturing. Increasing this value decrease CPU load, but decrease dominant color extraction presision as well. Alienfx Update Lights WitDefault value is 8, ok for 4k screen with i7 CPU, you can increase it if update lights wit a delay, or decrease if it works ok for you. First, use Devices and Lights tab to configure out devices and lights settings, if you dont run alienfx-probe yet. Use Color tab for simple lights setup (this colors and modes will stay as default until AWCC run or modified by other app), even after reboot. You can also assign event for light to react on (power state, performance indicator, or just activity light), as well as a color for reaction at Monitoring tab.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |